DIMM Installation
![]() |
---|
HAZARD OF ELECTRIC SHOCK, EXPLOSION,
OR ARC FLASH
Failure to follow these instructions will result in death or serious injury.
|
![]() |
---|
MEMORY MODULE DAMAGE AND DATA
LOSS
Failure to follow these instructions can result in injury or equipment damage.
|
NOTICE |
---|
ELECTROSTATIC
DISCHARGE
Take the necessary protective measures
against electrostatic discharge before attempting to remove the cover.
Failure to follow these instructions can result in equipment damage.
|
NOTICE |
---|
BROKEN ENCLOSURE
Do not exert more torque than the amount specified.
Failure to follow these instructions can result in equipment damage.
|
- Disconnect the power supply from the Box Module.
- Touch the housing or ground connection (not the power supply) to discharge any electrostatic charge from your body.
- Remove 5 screws of the maintenance hatch cover and slide the cover to remove.
- As shown below, insert the DIMM module diagonally, then push from above.
- Replace the maintenance hatch cover and tighten the screws.NOTE: The necessary torque is 0.3 N•m (2.7 lb-in).