Contact us
Back to Top


IO Driver (FLEX)

Click an error ID to see the details.


Error Message

Not supported unit.
RGE*002 Illegal Parameter
RGE*003 Device offset beyond limit.
RGE*004 Terminal config overlapped.
RGE*005 Illegal terminal sequence.
RGE*006 Insufficient terminals.
RGE*007 Units config overlapped.
RGE*008 Units count over limit.
RGE*009 Drivers config overlapped.
RGE*010 Unmatched In/Out terminal.
RGE*011 Unmatched bit/word term.
RGE*012 Illegal level number.
RGE*013 Illegal data addr. Gotten
RGE*014 No drivers/units registered.
RGE*100 Unit communication error.
RGE*101 4ch. analog setting error.
RGE*102 2ch. analog setting error.
RGE*103 Analog unit's wire broken.
RGE*104 Counter unit's error.
RGE*105 Counter initial error.
RGE*106 Counter communitation err.
RGE*107 Positioning Unit's error.
RGE*108 Comm. position error.
RGE*109 2ch. analog comm. error.
RGE*200 SetValue func.(INT) NG.
RGE*201 SetValue func.(bit) NG.
RGE*202 GetValue func.(INT) NG.
RGE*203 GetValue func.(bit) NG.
Back to page top Return to the previous page
FAQ for use | Protection of Personal Information | Trademark Acknowledgments | About Intellectual Property Rights | Terms of Use
Copyright (C) 2005- Schneider Electric Japan Holdings Ltd. All Rights Reserved.