Otasuke Pro! > FAQ > GP3000 > RGE*100_Unit communication error

FAQ

RGE*100_Unit communication error

Error Description

The error message [RGE*100_Unit communication error] appeared on the GP3000 screen.

Cause

A communication error has occurred between the main unit and the Flex Network unit;
the communication cable is disconnected, the Flex Network unit isn't connected, or an incorrect unit model is set in the project file.

Solution

1.	Check if the communication cable is connected properly.
	→	Click here for information on how to connect Communication Cables.
2.	Check if the transmission speed of Flex Network unit or the S-No settings are matched to the settings in GP-Pro EX.
	→	Refer to the Users Manual of each unit for information on how to set the transmission speed and S-No on the display unit.
	→	Click here for information on how to set the transmission speed and S-No on GP-Pro EX.

↑Back to page top

← Return to the previous page

FAQ for use | Protection of Personal Information | Trademark Acknowledgments | About Intellectual Property Rights | Terms of Use