Otasuke Pro! > FAQ > GP3000 > RGE*108

FAQ

RGE*108_Comm. position error

Error Description

The error message [RGE*108_Comm. position error] appeared on the GP3000 screen.

Cause

A communication error with the single-axis positioning unit has occurred;
the communication cable is disconnected, the single-axis positioning unit isn't connected, an incorrect unit model is set in the project file.

Solution

1.	Check if the communication cable is connected properly.
	→	Click here for information on how to connect communication cables.
2.	Check if the transmission speed of the single-axis positioning unit or S-No settings are matched to the settings in GP-Pro EX.
	→	Click here for information on how to set the transmission speed and S-No on the single-axis positioning unit.
	→	Click here for information on how to set the transmission speed and S-No on GP-Pro EX.

↑Back to page top

← Return to the previous page

FAQ for use | Protection of Personal Information | Trademark Acknowledgments | About Intellectual Property Rights | Terms of Use