Removal Procedure from DIN Rail and Panel
This section describes how to remove the rear module from a DIN rail and the display module from the panel.
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
Failure to follow these instructions will result in death or serious injury.
Be sure to remove the separation cable from the display module without twisting.
Failure to follow these instructions can result in equipment damage.
- Push and hold the button at the top of the rear module, and pull the rear module straight out.
- Push down on the rear module installation adapter and unhook the bottom part of the adapter from the DIN rail.
- Push and hold the button at the top of the separation cable, and pull the separation cable straight out.
- Remove the nut and the display module from the panel.