Use and store this product in areas that conform to the specified conditions.
|Ambient air temperature||0...50 °C (32...122 °F)|
|Storage temperature||-20...60 °C (-4...140 °F)|
|Ambient air and storage humidity||10...90% RH (non condensing, wet bulb temperature 39 °C [102.2 °F] or less)|
|Dust||0.1 mg/m3 (10-7 oz/ft3) or less (non-conductive levels)|
|Pollution degree||For use in Pollution Degree 2 environment|
|Corrosive gases||Free of corrosive gases|
|Atmospheric pressure (operating altitude)||800...1,114 hPa (2,000 m [6,561 ft] or lower)|
5...9 Hz Single amplitude 3.5 mm (0.14 in)
9...150 Hz Fixed acceleration: 9.8 m/s2
X, Y, Z directions for 10 cycles (approximately 100 minutes)
147 m/s2, X, Y, Z directions for 3 times
|Electrical fast transient/burst immunity||IEC 61000-4-4
2 kV: Power port
1 kV: Signal ports
|Electrostatic discharge immunity||Contact discharge method: 6 kV
Air discharge method: 8 kV
(IEC/EN 61000-4-2 Level 3)
Air Quality Requirements
Do not operate or store the product where chemicals evaporate, or where chemicals are present in the air:
Corrosive chemicals: Acids, alkalines, liquids containing salt.
Flammable chemicals: Organic solvents.
Do not allow water, liquids, metal, and wiring fragments to enter the panel case.
Failure to follow these instructions can result in injury or equipment damage.