STC6000-MM01-EN.02

DIO Interface Cable Preparation

  • If the ends of the wires are not twisted correctly, the wires may create a short circuit.

  • Strip wires only to the required length. If the strip length is too long, the conductive part may protrude from the wire insertion opening and may cause an electric shock or a short circuit with other wires. If the strip is too short, the wire contact may not be a good conductor.

  • Do not solder the stranded wire. This could lead to a bad or poor contact.

  • When wiring, pay attention to the wire arrangement, installation position and direction to minimize stress on the connector. Affix the cable near the product by using the cable clamp and set it loosely as not to place tension on the connector.

  • The connectors are a spring clamp type.

DIO cable cross sectional area

0.20…0.82 mm2 (AWG 24…18)

(UL1015 or UL1007)

Conductor type

Stranded wire

Conductor length

Recommended screwdriver*1

Blade thickness: 1.5 mm (0.06 in)
Blade width: 2.4 mm (0.09 in)

*1 The screwdriver tip should be flat, as indicated, in order to access the narrow hole of the connector. The point shape must be DIN5264A and meet standard DN EN60900.

Shape of the screwdriver tip

Search Results (0)

Close