FAN Kit
Introduction
On the Advanced Box, you can install an optional FAN kit (PFXYP6FAN).
Rated input voltage | 12 Vdc |
Power consumption (max.) | 4.08 W |
Installation
![]() |
---|
HAZARD OF ELECTRIC SHOCK, EXPLOSION,
OR ARC FLASH
Failure to follow these instructions will result in death or serious injury.
|
NOTICE |
---|
ELECTROSTATIC
DISCHARGE
Take the necessary protective measures
against electrostatic discharge before attempting to remove the cover.
Failure to follow these instructions can result in equipment damage.
|
NOTICE |
---|
BROKEN ENCLOSURE
Do not exert more torque than the amount specified.
Failure to follow these instructions can result in equipment damage.
|
- Disconnect the power supply from the Box Module.
- Touch the housing or ground connection (not the power supply) to discharge any electrostatic charge from your body.
- Remove 5 screws of the maintenance hatch cover and slide the cover to remove.
- When equipped with M.2 SSD, remove the heat sink and heat sink pad (for top) before installing the FAN kit. For information on the heat sink and heat sink pad for M.2 SSD, see M.2 SSD Installation.
- Connect the cable of the FAN kit to the connector in the maintenance hatch.
- Using the screws removed in step 3, secure the FAN kit.