7.1 Settings Menu

Connecting to Multiple Device/PLCs

Overview 7.2 Connecting to Multiple Device/PLCs

Steps 7.2.1 Procedure - Connecting to Multiple Device/PLCs

 

Disconnecting Multiple Connected Devices/PLCs

Overview 7.3 Disconnecting Multiple Connected Devices/PLCs

Steps 7.3.1 Procedure - Stop Communications

Steps 7.3.2 Procedure - Confirming the Communication State

To stop the display unit from scanning for a device/PLC, set the communication bit to OFF.

 

Changing a Device/PLC

Overview 7.4 Changing a Device/PLC

Steps 7.4.1 Procedure - Converting the PLC type without designating an Address Conversion Range

Steps 7.4.2 Procedure - Converting the PLC type and designating an Address Conversion Range

 

Connecting Multiple Display Units to One PLC

Overview 7.5 Connecting Multiple Display Units to One PLC

Steps 7.5.1 Procedure - Connecting Multiple Display Units to One PLC

Steps 7.5.2 Procedure - How to Calculate the Communication Traffic

 

In a Multiple Display Unit Environment, Make Only One Active

Overview 7.6 In a Multiple Display Unit Environment, Make Only One Active

Steps 7.6.1 Procedure - In a Multiple Display Unit Environment, Make Only One Active