Frequently asked Question
I/O does not work at all. What should I do?
Check the following 5 items.
1.
Is it [
Enable I/O
] with the LT Editor?
2.
Is the LT in the RUN mode?
3.
Is the RUN/STOP SW run on the rear side of the LT?
4.
Is the wiring correct?
5.
Is the logic program correct?
Also, if you want to make the state [Enable I/O] at the time of boot, see
here
Return to Top
Back
FAQ for use
|
Protection of Personal Information
|
Trademark Acknowledgments
|
About Intellectual Property Rights
|
Terms of Use
Copyright
(C) 2005- Schneider Electric Japan Holdings Ltd. All Rights Reserved.