Products
Download
Contact us
Back to Top
Otasuke FAQ's Book
 Frequently asked Question
The sensor or the lamp that is connected to the LT does not respond. What should I do?

Check the following 5 items.


1. Is it [Enable I/O] with the LT Editor?
2. Is the LT in the RUN mode?
3. Is the RUN/STOP SW run on the rear side of the LT?
4. Is the wiring correct?
5. Is the logic program correct?

Also, if you want to make the state [Enable I/O] at the time of boot, see here.
 
 
Return to Top Back
FAQ for use | Protection of Personal Information | Trademark Acknowledgments | About Intellectual Property Rights | Terms of Use
Copyright (C) 2005- Schneider Electric Japan Holdings Ltd. All Rights Reserved.