|
In case that the EX module is attached properly
|
| 1. |
Turn off the LT and remove the terminal connector or the MIL connector. Turn on the LT and check if LED of the EX module is lighting or not.
|
|
|
|
LED is lighting |
|
Turn off the LT. Attach the terminal connector or the MIL connector again and check if it can communicate.
|
|
→
|
LED is not lighting |
|
The EX module is not recognized. Please contact your local distributor.
|
|
|
In case that the EX module is not attached properly
|
| 1. |
Turn off the LT, and attach the extend connector properly. Check if the connector pin is not bent or damaged
|
| 2. |
Select [Peripheral Settings] → [EXM Driver] → [I/O Monitor] on the offline mode of the main unit. If the module number and the module type are not displayed, the EX module is not recognized. Please contact your local distributor.
|
|
|
