Otasuke Pro! > FAQ > GP3000 > The GP unit displays an error message: "There are features unsupported by this model. Please check the settings then transfer the project again."

FAQ

The GP unit displays an error message:
"There are features unsupported by this model. Please check the settings then transfer the project again."

If your GP unit is a GP-3300 model with the revision number lower than Rev.*-4 and you transfer a project file to the GP unit with the [Revision] set to [Rev*-4 Greater Than Or Equal To], the following message will appear and the GP may not run properly. Data stored on the GP before transferring is also deleted.

If the revision number of your GP model is lower than Rev.*-4, please make sure to set [Revision] to [Rev*-4 Less Than]. When designing the screen display, do not use any features unsupported by models lower than Rev*-4.

NOTE

-	Transfer operations include all transfer operations, such as CF Card Connection, Memory Loader, and transferring between the computer and the display uint.

↑Back to page top

← Return to the previous page

FAQ for use | Protection of Personal Information | Trademark Acknowledgments | About Intellectual Property Rights | Terms of Use