Contact us
Back to Top
 File Register Settings (When using Mitsubishi Electric Corporation's PLC)

For setting the File Register with GP3000 series, there are 2 kinds of settings, [0R~31R] and [ZR] in the device setting column.
When a project file is created with GP-PRO/PBIII and it is converted with GP-Pro EX, the file is converted to [0R - 31R] of the traditional File Register in order to keep conpatibility. When setting the File Register newly with GP3000 series, it's recommended to select [ZR] according to PLC. There's no difference of implications between [ZR] and [0R - 31R].
For Convert Addresses in block, when converting the File Register's [0R~31R] to [ZR], it's necessary to repeat conversion for each block 32 times in total (like 0R, 1R...). It's the same for the opposite case.
Back to page top Return to the previous page
FAQ for use | Protection of Personal Information | Trademark Acknowledgments | About Intellectual Property Rights | Terms of Use
Copyright (C) 2005- Schneider Electric Japan Holdings Ltd. All Rights Reserved.