Products
Download
Contact us
Back to Top
Otasuke FAQ's Book
 FAQ
 What is the address shown as % in the Pro-Control Editor?

This is the address managed inside the software. No need to care about it specially, but refer it as a specific place of I/O setting.  
- GP-PRO/PB3 C-Package03
  1. In the Pro-Control Editor, click on [Data] in the menu bar -> [Configure I/O]. Then, [Configure I/O] window appears.
   
     
  2.

The notation written in the right side of the variable as (%IX1.0.0) is the I/O address.

   
     
- LT Editor
  1. In the Logic Program Editor, click on [Data] in the menu bar -> [Configure I/O]. Then, [Configure I/O] window appears.
   
     
  2.

The notation written in the right side of the variable as (%IX1.0.1) is the I/O address.

   
Return to Top Close
FAQ for use | Protection of Personal Information | Trademark Acknowledgments | About Intellectual Property Rights | Terms of Use
Copyright (C) 2005- Schneider Electric Japan Holdings Ltd. All Rights Reserved.