
Important notice to our valued customers who use address format in register variable of the logic program setup of GP-Pro EX(Update)
Last Updated: Jul. 19, 2013
Posted: Apr. 15, 2013
Posted: Apr. 15, 2013
Thank you very much for your continuous use of Pro-face products.
We have confirmed that the following symptom occurs in some models of GP-Pro EX.
The symptoms and corrective measures for this problem are indicated below.
We sincerely apologize for any inconvenience this may cause you.
We have confirmed that the following symptom occurs in some models of GP-Pro EX.
The symptoms and corrective measures for this problem are indicated below.
We sincerely apologize for any inconvenience this may cause you.
Symptom descriptions
When register variable of logic program setup is set as an address format, if Timer and Counter command are used, a preset value will not be saved.
If register variable is variable format, it will operate satisfactorily.
Applicable combination of products
The followings are applicable products
Applicable models of Graphic Operator Interfaces:
Series | Applicable models |
---|---|
GP4000/GP3000/LT3000 Series | All models |
Applicable product of Screen Editor Software:
Product model : | PFXEXEDV31 |
---|---|
Applicable version : | GP-Pro EX Ver. 3.10.000 |
How to check the version : | [Help (H)] → [About this program (A)] |
Measures
Download and install the following module.
→GP-Pro EX Update Module(Ver. 3.12.000 or later)
To download the module, free member registration for “Otasuke Pro!” is required. Click here to register.
→GP-Pro EX Update Module(Ver. 3.12.000 or later)
To download the module, free member registration for “Otasuke Pro!” is required. Click here to register.
Inquiry
If you have any inquiries, please contact our sales office in your region.
For contact information, please refer to the "Inquiry" page.