Introduction
You can use the following methods to install the box module.
-
Wall mounting
-
Flat mounting
-
Book mounting
Each installation method is described below.
-
Depending on the panel’s material and design, the panel’s installation surface may need to be strengthened. If high levels of vibration are expected and this product’s installation surface can move (such as because of a panel door opening or closing), due consideration should be given to this product’s weight.
-
Determine the thickness of the panel in consideration of its material and strength as well as the environment in which this product is used. The thickness must be 1.6 mm (0.06 in) or more, considering the length of M4 screws.
-
There is a decal attached to the rear face of the Box Module. Do not remove this decal; otherwise, the Box Module will not function properly.
-
When using the following interfaces, be careful when mounting the Box Module by itself with either wall mounting or flat mounting.
-
RS-232C isolated x 2
-
RS-422/485 isolated x 2
If you purchased the Standard Box with the above interface, remove the interface, mount the Box Module to the panel, then re-attach the interface. After purchasing, when attaching the above interface to the Standard Box or to interface slot 2 on the Advanced Box, first mount the Box Module to the panel, then attach the interface.
-
DANGER |
---|
HAZARD OF ELECTRIC SHOCK, EXPLOSION,
OR ARC FLASH
Failure to follow these instructions will result in death or serious injury.
|
CAUTION |
---|
RISK
OF INJURY
Failure to follow these instructions can result in injury or equipment damage.
|
NOTICE |
---|
EQUIPMENT DAMAGE
Failure to follow these instructions can result in equipment damage.
|
NOTICE |
---|
BROKEN ENCLOSURE
Do not exert more torque than the amount specified.
Failure to follow these instructions can result in equipment damage.
|