When using the STM-6B00, attach the rear module installation adapter.
When using offline mode, make sure you use with the display module attached. It may not be possible to determine whether setup was completed properly.
In the System Settings [Display Unit] - [Remote Viewer], select [Pro-face Remote HMI] - [Enable]. If an error occurs, you can check them with the Pro-face Remote HMI.
When using the feature that stores the status in the internal device or the device/PLC address, design so that the external device can detect any display unit errors, as needed, by monitoring address values or using I/O.
When transferring the project over Ethernet, transfer using the factory set IP address.
34.3.3 Transfer - Transferring Projects Using the Factory Set IP Address