31.8.1 Procedure - Controlling External I/O in STC6000 Series and TM3 Modules

Settings for the TM3 modules are shown below.

From the [Project] menu, point to [System Settings] and click [I/O Driver]. Click the [External Driver] tab.
Click [Add Module] to display the [Module Details] dialog box. Specify the TM3 module type and click [OK].
The module-specific settings appear. For details about each, see the Settings Guide.
To add, change, and delete modules, click the module and one of the buttons shown below.

A limited number of units can be connected to a TM3 module. Please refer to the following for details.
31.8.4 Restrictions - STC6000 and TM3 Module - Number of TM3. Modules That can be Connected
If the number of connected units exceeds the limit, the following dialog box will appear when you click the [Add Module] button.