
Notes for using PS-3700A series
Thank you very much for your continuous use of Pro-face products.
We have confirmed that the following symptom has been seen in PS-3700A Series.
The symptom for this problem are indicated below.
We sincerely apologize for any inconvenience this may cause you.
Outline
PS-3700A series have two slots of PCMCIA slot.
These cannot be operated simultaneously in the configuration that is shipped due to lack of IRQ (Interrupt ReQuest) .
Target Customers
The customers using PS-3700A series.
Targeted OS
PS-3700A Pentium® 4 model | Windows® 2000, Windows® XP |
PS-3700A Eden™ model | Windows® 2000, Windows® XP, Windows® XP Embedded |
PS-3701A | Windows® XP, Windows® XP Embedded |
Occurrences
- Blue screen (and PS-3700A reboots)
- The second PCMCIA card has "!" mark when starting device manager.
Solution
® 4 model>
BIOS setting will be changed; one of Onboard Serial Ports is to be disabled.
1. Open BIOS set-up window by keeping pressing [Del] key.
2. Start menu of "Integrated Peripherals"
3. Set one of Onboard Serial Ports from 1 to 4 [Disabled]
4. Save the setting by pressing [F10].
(Windows® 2000)
BIOS setting will be changed; one of Onboard Serial Ports is to be disabled.
1. Open BIOS set-up window by keeping pressing [Del] key.
2. Start menu of "Integrated Peripherals".
3. Set one of Onboard Serial Ports from 1 to 4 [Disabled].
4. Save the setting by pressing [F10].
(Windows® XP, Windows® XP Embedded)
BIOS setting will be changed; either COM3 or COM4 is to be disabled.
1. Open BIOS set-up window by keeping pressing [Del] key.
2. Start menu of "Integrated Peripherals".
3. Set either Onboard Serial Port 3 or 4 [Disabled].
4. Save the setting by pressing [F10].
(Windows® XP, Windows® XP Embedded)
BIOS setting will be changed; both IPQ10 and 11 is set [Legacy ISA].
1. Open BIOS set-up window by keeping pressing [Del] key.
2. Start menu of "PnP/PCI Configuration".
3. Change "Resource Controlled By" in "PnP/PCI Configuration" [Menu].
4. Point the cursor to [Press Enter] in IRQ Resources, and press Enter.
5. Change [IRQ-10 assigned to] and [IRQ-11 assigned to] to [Legacy ISA].
6. Save the setting by pressing [F10].
Inquiry
If you have any inquiries, please contact our sales office in your region.
For contact information, please refer to the "Inquiry" page.