Alarm Messages are displayed in a row in order of when they were triggered.
Display Format
Set the format of the Alarm History display.
Block
Select how to specify the display block from either [Direct] or [Address].
Display Block
When the [Block] is set to [Direct], select the registered block with the alarm message to be displayed from [Block 1] to [Block 8]. When the [Block] is set to [Address], set the address specifying the block to be displayed.
When a communication error occurs at the block address, the Alarm History display is discontinued. If a Communication Error is recovered when the Alarm Monitor Address has met its Trigger Conditions, the message triggered during recovery is displayed on the parts.
Display Mode
Choose the Alarm Message display method from [History], [Log], or [Active].
Message Display Method
Select a way to display the Alarm Message.
1 line display
Displayed on one line with other items such as Date or Trigger Time.
Multiple line display
Displays only alarm messages on a separate line from other items.
Lines per Message
When [Alarm Parts]-[Basic]-[Message Display Method]-[Multiple line display] is selected, set the number of lines for messages from 1 to 5.
The number of lines set here applies to all messages. If the message can fit in less than the set number of lines, the blank lines will also display.
Display Start Row
Set the row where the Alarm Message will start displaying from 1 to 768.
Display Alarms
Set the amount of alarms to display in the alarm part, from 1 to 50.
Display Row Spacing
Set the space between Alarm Messages from 0 to 7 dots.
