37.10.4.1 Procedure - Sending E-mail with Alarm Trigger/Recovery

This example shows how to sent e-mail at alarm trigger and recovery.

E-mail Settings

1. From the [Project (F)] menu, select [System Settings (C)] - [E-mail (A)].
   See the following for the settings. Settings for [Control Word Address] and [Attachment File Name] are not required.

   37.10.3.1 Procedure - Sending E-mail

Alarm Settings

1. From the [Common Settings (R)] menu, select [Alarm (A)], or click .

2. In the Block Settings, select the check box of the block associated with the registered message and of the display mode (History/Log/Active) you want to use, and set the number of messages stored as history in each mode.

   

3. Select the [Send E-mail] check box and the Alarm block numbers that you want to send e-mail.

   

4. Select a number for [Receiver Groups]. Specify the receiver group number configured in [System Settings] - [E-mail] - [Receiver Groups] tab.

5. Select alarm states to trigger sending e-mail.

6. Open the [Block 1] tab and set up the alarm.