Important notice to our valued customers who use the parts of BOOL type with OMRON Electric Corporation CS/CJ/NJ Series EtherNet/IP Driver
Last updated: May 14, 2013
Posted: May 13, 2013
We have confirmed that the following symptom occurs in some models of GP-Pro EX.
The symptom and corrective measures for this problem are indicated below.
We sincerely apologize for any inconvenience this may cause you.
Sympton descriptions
If ‘OMRON Electric Corporation CS/CJ/NJ series EtherNet/IP Driver’ uses a BOOL type in NJ series, and assigns and reads parts on the screen of GP or writes in, GP main part may freeze.
If it is use of those other than the BOOL type of the member of a structure, a problem will not occur.
Applicable combination of products
The followings are applicable products
Applicable models of Graphic Operator Interfaces:
| Series | Model |
|---|---|
| GP4000 Series | All models (including WinGP) |
| GP3000 Series | |
| LT3000 Series |
PLC driver:
Omron CS/CJ/NJ Series EtherNet/IP Ver. 1.15.02
The above driver is for the customers who downloaded the driver of corresponding version from our homepage.
(Screen Creation Software "GP-Pro EX" does not include the above driver.)
Measures
Download the update module from our website to update your GP-Pro EX.
To download the module, free member registration for "Otasuke Pro!" is required. Click here to register.
Inquiry
If you have any inquiries, please contact our sales office in your region.
For contact information, please refer to the "Our Locations" page.