Products
Download
Contact us
Back to Top
FAQ
 RGE*101_DIO write data error

Error Description
The error message [RGE*101_DIO write data error] appeared on the GP3000 screen.

Cause
Although data was output to the DIO board, it was not output when the output result was fed back. This may be caused by noise or GP unit failure.

Solution
If this error occurs frequently, the unit may be faulty. Please contact your local GP distributer. This error code continues appearing until the controller is reset.
↑Back to page top ← Return to the previous page
FAQ for use | Protection of Personal Information | Trademark Acknowledgments | About Intellectual Property Rights | Terms of Use
Copyright (C) 2005- Schneider Electric Japan Holdings Ltd. All Rights Reserved.