|
Error Message |
Cause and Solution |
Reference |
|
RAAA012:The project data contains functions that are not supported by this model. |
Simulation does not support all features. You can only simulate supported features. Please refer to the next cell for unsupported features. |
|
|
RFAJ034: Error has been responded for device read command (Error code: ***) |
Failed to read device. For error codes, see the MX Component manual. |
— |
|
RFAJ035: Error has been responded for device write command (Error code: ***) |
Failed to write device. For error codes, see the MX Component manual. |
— |
|
RFAJ049: Unknown devices exist in read devices |
Please check if the device address range, device/PLC settings, and CPU type are correct. |
— |
|
RFAJ050: Unknown devices exist in write devices |
Please check if the device address range, device/PLC settings, and CPU type are correct. |
— |
|
Please stop and exit the simulation to continue. |
The user tried to close the Editor during simulation. Before closing the Editor, complete simulation. |
|
|
Cannot change language during simulation. |
The user tried to change the operating language in the Editor [Option Settings] when simulation was in progress. Before changing the operating language, complete simulation. |
|
|
The simulation could not be started. |
Simulation does not start due to some problem. The file may have been broken. Reinstall GP-Pro EX. |
|
|
Cannot input the key code during simulation. Exit simulation and then enter the key code. |
Before inputting the key code, complete simulation. |
|
|
Failed to start Simulation due to project error. Run Error Check to find problems. |
The simulation did not start due to a problem with communication with a connected device. Run the simulation after an error in the project file is corrected. |
— |
|
Unable to connect to GX Simulator. |
GX Simulator is not running, or CPU type is different. Please first start GX Simulator. Please check the CPU type set up in GX Developer. |
— |
|
MX Component is not installed. |
Please re-install MX Component on the computer. |
— |
|
Failed to connect to GX Simulator (Error code: ***) |
Please restart both GP-Pro EX Simulation and GP-Developer. For error codes, see the MX Component manual. |
— |
