The important information for the users of GP-PRO/PB III for Windows Ver. 5.05.

We discovered a problem in our software "GP-PRO/PB III for Windows Ver. 5.05." This page contains information about the problem and the solution. We apologize for any inconvenience this may cause.

Affected Users

Install the fix module provided by Microsoft Corporation.

Corresponding Screen Creation Software's Version Corresponding Units System Program's Version of Corresponding Units GP-PRO/PB III for Windows Ver. 5.05. GP77R Series: GP-477RE, GP-577RT, GP-577RS, GP-377RT, EXGP-577RT Ver. 2.66a to Ver. 2.66b GP377 Series: GP-377S, GP-377L, GP-37W2 Ver. 2.66a to Ver. 2.66b GP2000 Series: GP-2400T, GP-2500T, GP-2501T, GP-2600T GLC2000 Series: GLC2400T, GLC2600T Ver. 3.20 to Ver. 3.22

Problem

If alarm messages on the screen of GP-PRO/PB III for Windows Ver. 5.05 are not displayed when "a tag" or "Alarm Summary Part" are set, it is possible that the GP unit is locked. The frequency of this occurrence is low. In addition, this problem is found in only Ver. 5.05. The other versions have no problem.

Solution

Download the update package in the following page, and update GP-PRO/PB III for Windows Ver. 5.05. This will avoid the above problem. - GP-PRO/PB III for Windows Members Club     "GP-PRO/PB III for Windows Ver. 5.0 New System Update Modules"

Notes: "GP-PRO/PB III for Windows Ver. 5.0 New System Update Modules" can be downloaded from the "GP-PRO/PB III for Windows Members Club" page. To access this page you must have previously purchased and registered a copy of "GP-PRO/PB III for Windows" or "GP-PRO/PB III C-Package02".

Supplement

The unit's system version can be checked in the following way. Depending on the system, however, it is possible that peripheral equipment could be influenced by the version check while the system is working. Before checking the version, please make sure peripheral equipment is not influenced by the version check, even if the unit is reset or restarted. If you do not know whether peripheral equipment will be affected, the version check should be done after shutting down the system.

1. Enter the offline mode, select "Initial Setting" from the main menu. 2. Select "set the system environment". 3. Select "set the system". 4. Select "start time [second]" and set 5 seconds. 5. Back to "main menu" and select "operation", or turn ON or OFF the power supply to the GP unit. 6. The GP unit is reset, and the system starts in 5 seconds. During these 5 seconds, the system version is displayed in the bottom right of the screen.     For further information, please see the chapter "Offline Mode" in each unit manual.