Otasuke Pro!> FAQ > GP3000 > RHAA035(Node Name): Error has been responded for device write command (Error Code: (Decimal)[(Hex)])

FAQ

RHAA035(Node Name): Error has been responded for device write command
(Error Code: (Decimal)[(Hex)])

Error Details

The error message [RHAA035(Node Name): Error has been responded for device write command (Error Code: (Decimal)[(Hex)])] appeared on the GP3000 screen.

Causes

1.	The communication settings of the GP unit and those of the device/PLC are not matched.
2.	Wiring has problems such as a wrong wire connection or a loose connection.
3.	The correct type of the device/PLC is not selected.
4.	Addresses out of the range are set.

Actions

Check the communication settings of the GP and the device/PLC. If they are not matched, change the communication settings to match them.

→ Communication Settings on the GP unit
→ Communication Settings in GP-Pro EX

Rewire if there is a problem in the communication cable wiring or a loose connection. For details of cable diagrams between a GP unit and a device/PLC, please refer to the GP-Pro EX Device/PLC Connection Manual.

Change the type of the device/PLC to the one currently connected.

→ How to check the type of Device/PLC on the GP unit
→ How to change the type of Device/PLC in GP-Pro EX

Check the address range of the device/PLC in use. Addresses out of the range may be set.

About error codes

・	Error codes are sent from a device/PLC. Please refer to the manual of the device/PLC for the error details.

↑Back to page top

← Return to the previous page

FAQ for use | Protection of Personal Information | Trademark Acknowledgments | About Intellectual Property Rights | Terms of Use