Products
Download
Contact us
Back to Top
 FAQ
 I can not input numbers with Numeric Keypad.

 
Is K Tag or Keypad Input Display in the condition to receive input?

   
  In case of using K Tag, please check whether [Trigger Bit Address] is ON or not.
   
  In case of using Keypad Input Display, Input Actions, [Touch] or [Bit], can be selected.
 
   
 
Selecting Touch
Please touch the top of Keypad Input Display to enable to receive input.
Selecting Bit
It is not possible to input unless [Trigger Bit Address] is ON.
   
   
Please set Bit Address ON/OFF by force by PLC.

   
  Being connected to PLC or Temperature Controller
  Please STOP the program of PLC and change Bit Address of PLC with Ladder Software, or so on by force. Please confirm the Display of GP at that time.
   
  Being connected to Board Computer with Memory Link Type.
  Please STOP the program of HOST and change only Bit Address by force. Please confirm the Display of GP at that time.
   
   

Are you using U Tag/Window Parts?


   
  Please check whether you have called K Tag/Keypad on Window or not.

if you call them on Window, they may not operate correctly .

   
   
Does the Keypad beep when clicking [ENT] Key?

   
 

In case of beeping when you click [ENT] Key, [Alarm Settings] of K Tag or Keypad Input Display is set.

If [Alarm Settings] is set, when you input the data out of the Alarm Range, the Keypad will beep and Input will be canceled.

 
   
Please try Rebuild or Force System Setup.

   
 
   
 

Other Checking Points

In case that [Data Type] is [Relative]
Please check Input Range and Display Range are correct in case that [Data Type] of K Tag/Keypad is set as [Relative].
In case of that [Color Settings] is [Indirect]
Please check the data of Display Color is correct in case that [Color Settings] of K Tag/Keypad is set as [Indirect].
Checking Number of Tags
The Number of Tags (including Parts) which are available on one screen (including Current Window Screen) is up to 128 for GP270/GP370/GPH70, up to 256 for GP70 Series, and up to 384 for GP77/ GP77R/GP2000 Series.

Depending on the Tags, Maximum Number which can be set is not 384(254/128) for some Tags.

Please refer Tag Reference Manual.

Simulation Mode

(GP70/77 Series only)

Please check whether Simulation Mode is displayed or not.

If you can see SIM-LINK at the bottom left of the screen on Offline Mode, Simulation Mode is running. When you transfer, please check off [Send Simulation Data] of [Transfer Settings] .

 
 
Return to Top Back
FAQ for use | Protection of Personal Information | Trademark Acknowledgments | About Intellectual Property Rights | Terms of Use
Copyright (C) 2005- Schneider Electric Japan Holdings Ltd. All Rights Reserved.