Display during start-up is different than setup. |
1. When Start Time is set to 0 second. |
|
The following version information is displayed after power-on. Then the screen number is displayed according to initialization screen ( setup in Initialize / Screen setup) is displayed, and the GP starts to communicate with the PLC.
|
 |
Depending on the startup time of the display version information might not be displayed.
If the initialization screen's file number is not designated, or a number is designated that does not exist, the version information screen will remain. |
2. When Start Time is set to any value other than 0 seconds.. |
|
When the GP power on, the following version information screen will appear. In the top right corner of the screen, a value will appear and count down the number of seconds according to the START TIME setting.
|
 |
Depending on the startup time of the display version information might not be displayed.
If the initialization screen's file number is not designated, or a number is designated that does not exist, the version information screen will remain.
|
3. If the change screen number is set. |
|
If the change screen number is set in the PLC's system data area, the set change screen number is displayed after showing the screen by setting the file number of an initialization screen.
is displayed, and the GP starts to communicate with PLC.
If the screen change time is set as the change screen number, it is different from the timing of communication with the PLC. It may seem that the screen set as the initial screen was not displayed.
In addition, communication with PLC is not performed during countdown to a start time.
If the initialization screen's file number is not designated, or a number is designated that does not exist, the screen of the change screen number is displayed after showing the version information screen. |
Return to Top
Close