The barcode readers that have been tested and approved for the GP4000 / GP4000M / GP4100 / GP3000 / LT3000 series are as follows: |
|
: Operable |
- : Not Evaluated |
|
*1: Except GP3000H / GP3200 Series |
|
|
IMPORTANT |
- |
According to a manufacturing date, the above peripheral equipment might not be connected because a manufacturer changes specification. Be sure to check the operation before starting to use. |
- |
LT-3201A is not equipped with a serial port, and any barcode readers that requires a COM1 port can not connect to it. |
|
|
|
|
|
Restrictions on Keyence TL-70U |
When the [Code data in] setting is [Data Display], only English one byte characters and symbols can be read. |
When the [Code data in] setting is [Internal Device], two bytes characters can not be read. |
|
|
|
Restrictions on Tohken THLS-6910USB |
GP-Pro EX Ver. 1.01.004 or later is necessary. |
|
|
|
Restrictions on IDEC MG113041-000B |
Does not work with 5V power supply of a touch panel. Use external power supply. |
|
|
|
Restrictions on Opticon OPL-6845-USB |
The OPL-6845-USB software version FM22J03 or higher is required.
The system may not work properly if the firmware version of the barcode reader is lower than the above mentioned. Refer to the instruction manual attached to the barcode reader. |
|
|
|
Restrictions on Denso Wave QK11-U |
It can be operated through a self-powered USB hub. |
|