The [Selector Switch] cannot use the Delay feature.
ON Delay
If you take your finger off the switch before the Switch feature is enabled, it will have no effect. In that case, the switch appearance (color, label) will remain in the normal state and the buzzer (touch tone) will not sound.
If the Interlock feature is set, when Interlock is enabled, the ON Delay action will not occur.
Also, if Interlock is enabled during the ON Delay action (wait state), the wait state is canceled and the action does not occur.
If the screen changes or the Window closes during the ON Delay action (wait state), the wait state is canceled at the change time and the action does not occur.
If a bit operation occurs from the device/PLC during the ON Delay action (wait state), the ON Delay feature is disabled.
OFF Delay
Available when in the [Switch Feature] tab, [Bit Action] is [Bit Momentary].
Delay Feature does not function for the following switches which do not support momentary actions.
Bit Set
Bit Reset
Bit Invert
Comparison
Word Switch
If the screen changes during the OFF Delay action (OFF wait state), the screen changes after the OFF wait state is over.
If a OFF Delay action switch is on the window, the window will close after the OFF wait state is over.
Also, until the change screen and close window operations are complete, other parts will not run. As a result, if the OFF delay time is long, operations by other parts will also be delayed.
If a screen change request from the device/PLC occurs during the OFF Delay action, touch is disabled for the period of the delay time starting from after the screen change request.
Double Touch
If the specified time passes, the second touch has no effect.
If the Interlock feature is set, when Interlock is enabled, the double touch wait state will not occur.
Also, when Interlock is enabled during the double touch wait state, the 2nd touch cannot occur so the Switch will not become enabled.
If you touch a different Switch during the designated time, the double touch wait state is canceled.
If the screen changes or the Window closes during the designated time, the double touch wait state is canceled at the change time.
In the [Delay Feature] settings, if a switch is set up with the [Show In-Delay Status] check box selected, and a change screen operation occurs just before the switch enters delay mode, the switch drawing may not update.