You can transfer data between the display unit and a PC on a different network by using a router. However, there are cases where the PC cannot automatically search the display unit on a different network.
For a PC that is using two or more Ethernet cards, the desired display unit may not be detected even if the PC automatically detects IP addresses. This occurs when the PC searches the display units connected to the Ethernet card that was previously found. Click [Add] on the [Select Display Unit] dialog box and manually set the IP address of the display unit.
When using the Transfer Tool on a PC running Windows XP SP2 with Windows Firewall enabled, you are prompted to allow the transfer. If you transfer data to more than one display unit at the same time, either select [PASV] in the [Transfer Settings][Communication Port Settings] or disable Windows Firewall.