If the display unit does not already have a project in it, you cannot transfer via a modem.
You cannot transfer a new project via a modem. You can only use a modem to update the screen data of the project already on the display unit.
You cannot transfer the project file under the following conditions:
When system settings have changed
For project files created on a different version of GP-Pro EX (Note that you can transfer files as long as the run-time system, protocol driver, and I/O driver versions are the same.)
The modem connecting to the display unit must meet the following requirements.
Support AT commands
Allow automatic answering
Support hardware flow control
Modem that can return text with the result command
A modem can be used only after connecting to a specific operation center.
Since the display unit receiving modem is analog, you cannot use ISDN TA modem.
The modem connected to your PC must support AT commands. Use a Windows-compatible modem that can establish telephone communication with the modem connected with the display unit. A modem can be used only after connecting to a specific operation center.
For supported modem models, refer to the Pro-face support site "Otasuke Pro!" (http://www.pro-face.com/otasuke/).
Supported models may change due to version upgrades.
Modem transfer is not available when using WinGP.