30.5.10.2 Output Frequency - Acceleration/Deceleration Pulse Output (LT Series)

This function sets the pulse output frequency. You can use 10Hz to 65kHz for setting the output frequency. If you use the pulse output in multiple CHs, the total output frequency should not exceed 260kHz.

For pulse outputs, there is a limit to the maximum output frequency depending on the number of CH used.

30.5.13 Restrictions

Furthermore, you can set 2 types of output frequencies of the aforementioned acceleration/deceleration pulse and for the normal pulse in one CH. However, the total output frequency check is based on the normal frequency of acceleration/deceleration pulse or the normal pulse output frequency, whichever is larger.