You can paste to the desired position rungs that were cut or copied.
Here, paste the copied rung between the 3rd and 4th rungs, for example.
Select a part (power bar or instruction) immediately above where you want to insert the rung.
By clicking a rung number and selecting the entire rung, the original rung will be replaced with the copied rung.
Click the icon.
The rung copied on the clipboard is pasted below the selected rung.
You can also paste a rung in either of the following ways.
Right-click the destination and then click [Paste (P)].
Press CTRL+V.
When a rung is pasted, operands and rung comments in the rung instruction are also pasted. Edit the rung as required.
29.6 Allocating Addresses to Instructions
29.7 Input Comments