The following describes the specifiable content of operands S1 and D1 for the NOT and NOTP instructions.
The actual number of steps in the NOT and NOTP instructions depends on the specification method of the operand. The following describes how to calculate the number of steps.
Number of steps in operand S1 + Number of steps in operand D1 + 1 = Total number of steps in one instruction
For example, calculating the number of steps in NOT and NOTP instructions
(For the number of steps in an operand, refer to the operand settings as follows.)
{Data_1 = 1 step} + {Result [Specify indirectly] =3 steps} + {1 step} = 5 steps One last step is included in the instruction. Be sure to add that one step.