The following shows the configurable conditions for Operands (S1, D1) in the DEG/DEGP instructions.
The actual number of steps in the DEG/DEGP instructions depends on the specified operands. The following describes how to calculate the number of steps.
Number of steps in operand S1 + Number of steps in operand D1 + 1 = Total number of steps in one instruction
For example, calculate the number of steps in DEG/DEGP instructions
(For the number of steps in an operand, refer to the operand settings as follows.)
{Data_1 [0] = 2 steps} + {Conversion result [N] = 3 steps} + {1 steps} = 6 steps One last step is included in the instruction. Be sure to add that one step.