When [ASCII] is selected for the [Standard Font] under [Display Language], select a text size from the three fixed sizes: [6×10 pixels], [8×13 pixels], or [13×23 pixels].
When the [Character Size] is [6×10 pixels] fixed size, you cannot select [Bold] from the [Text Attribute].
When you display the text registered in a text table on a part with a [Fixed Size], refer to the ASCII text table and select or add the text for the part. Text on a table without ASCII language settings cannot be properly displayed on the GP.
If you change the font type to [Standard Font] after the text has been entered as a [Stroke Font], the text may not be displayed on the GP.
GP-32** Series and ST3000 Series cannot use the Font Area. When using a font other than [Japanese Standard Font], [English Standard Font] or [English Stroke Font], it uses the user screen area.
If using several types of fonts, the user screen area is used for the font area excess. Therefore, the screen data capacity is decreased.
When Standard Font is selected, special characters specific to languages that are not supported by Standard Font cannot be displayed properly.
Also, when the fixed size (6×10, 8×13, 13×23) is selected, characters other than the single-byte characters cannot be displayed properly.
You can enter text in [Comments], etc. using Unicode while pressing the [Alt] key, but you may not be able to enter Thai characters for the following settings using this method.
Enter [Comments] when changing the keypad attributes
Creating New a Image Unit Window, Enter [Comment]
Enter text for the [Display/CSV Save] Tab and the [Printing] tab in the sampling settings
Input message for Alarm settings
Input [Comments] when changing the [ID] of a D-Script
Built-in Functions of the D Script
Enter in [Find Comments] and [Search for Characters] in the Search Window
Enter rung comments in the logic screen