-
You can perform this setting when using the LT3000 series.
You can perform this setting when using the LT3000 series.
Recognition
Displays the [Recognition] screen.
I/O Monitor
Displays the I/O monitor screen.
Check I/O Board
Displays the Check I/O Board screen.
Recognition
Number of recognized addrs
Displays the total number of addresses found.
Recognized addresses
Displays a list of addresses found. Highlighted addresses (reversed) are outputs.
Start
Starts finding addresses.
The [Finding addresses] screen appears. Screen operations are not possible while processing. The addresses found are preserved even after restarting the display unit.
When there is an error during processing, the find address process stops and the error message displays. To run [Addr recognition] again, after resolving the error change the screen and touch [Start].
Error display
When an error arises, the error code and message will display. When there are multiple errors, only the first error message displays.
31.11.4.1 Error Code - AnyWire
I/O Monitor
I/O monitor start screen (Bit)
I/O monitor start screen (Word)
Input/Output
Select the monitored object's I/O, from either [Input] or [Output].
Area No. (0-27)
Set the monitored object's area number, from 0 to 27.
Type
Select the monitored object's [Type], from either [Bit] or [Word].
Input
When [Type]=[Bit]
Displays, from the AnyWire slave unit, the defined input area's input status in bits. When the switch is not pressed, the OFF value is displayed. When the switch is pressed, the ON value is displayed.
When [Type]=[Word]
Displays, from the AnyWire slave unit, the defined input area's input status as a word value.
Output
When [Type]=[Bit]
Displays, from the AnyWire slave unit, the defined output area's output status in bits.
When [Type]=[Word]
Displays, from the AnyWire slave unit, the defined output area's output status as a word value.
Error display
When an error arises, the error code and message will display. When there are multiple errors, only the first error message displays. For details about error messages, refer to the following.
31.11.4.1 Error Code - AnyWire
Check I/O Board
Start
The system starts checking if the I/O board is operating normally or not. If the I/O board operation is abnormal, the corresponding error message appears.
For details about error messages, refer to the following.