M.2.12 Deleting the touched position (When the GP-3200/ST3000 series is used)

The crosshairs cursor appears at the touch position on the screen. You can check for touch calibration errors based on the difference between the crosshairs cursor position and the drawing position.

If you wish to hide the cross cursor, perform the following setup procedure to hide the cursor.

For details about the setting screen, refer to the setting guide.
M.26.1.1 Main Unit - Display Settings

1. Go to offline mode and touch [Main Unit Settings] on the item changeover switch.

2. [Main Unit Settings] screen opens. Touch [Display Settings].

3. [Display Settings] window opens. In the [Display cross-hair cursor] field, select [Disable].

4. [Exit] Touch to use offline mode.