To use Auxiliary Lines, [Display Method] must be set to [Display Range].
When the value for the auxiliary line exceeds the graph display range, the auxiliary line will not display.
Upper Limit/Standard/Lower Limit
Select the auxiliary line to set.
Draw Line
Defines whether to draw the [Upper Limit], [Standard], and [Lower Limit] auxiliary lines in the selected positions.
Specify Display Position
Select the designation method of the auxiliary lines' display position from [Constant] or [Address].
Constant
Specify a set constant as the Display Position.
Address
Specify the address where the Display Position is stored.
Display Position
Select a display position for the auxiliary line.
Each auxiliary line's setting range is as follows.
Data Type |
Display Sign +/- |
Setting Range |
---|---|---|
16 Bit Bin |
Cleared |
0 to 65535 |
Selected |
-32768 to 32767 |
|
32 Bit Bin |
Cleared |
0 to 4294967295 |
Selected |
-2147483648 to 2147483647 |
Line Type
Select the auxiliary line type:
If the Graph screen is 16 pixels or less, any pattern other than a solid line may not properly display.
Line Thickness
Set the auxiliary line thickness from 1 to 2.
Display Color
Set the auxiliary line color.
Background Color
If you selected a line type other than a solid line, set the auxiliary line's background color.
Blink
Select the blink and blink speed. You can choose different blink settings for the [Display Color], and [Background Color].
Depending on your display unit's model and [Color] settings, you may not be able to set Blink (from the [Project] menu, point to [System Settings] and click [Display Unit]).
1.6 Supported Colors