The connection key is the key that enables communication between the display unit and either the GP-Pro EX Transfer Tool or GP-Viewer EX.
The connection key is set on each display unit.
When a connection key is set up, authentication of the key is required before sending or receiving project data or viewing the display unit screen on your computer.
If you forget the connection key, you will not be able to connect to the display unit.
The connection key is set the first time the project file is transferred. Enter offline mode to change or enable/disable the connection key. When entering offline mode on the GP-4G00 series, use Pro-face Remote HMI.
M.5.4 Changing the Connection Key
The connection key must meet the following requirements:
8 to 100 characters
Use at least one character from each of the following groups: Lowercase letter (a-z), uppercase letter (A-Z), number (0-9), and special character `()~!@#$%&:;.,-_{}*+=|<>?[]'"/\^
If 3 minutes elapse with the [Authentication] dialog box displayed, or an incorrect connection key entered, the connection is terminated.
For models that support the connection key, refer to the following.
1.5 Supported Features
When performing the following operations on the Transfer Tool, the connection key is required.
[Send Project], [Receive Project], [Compare Project], [Display Unit Information], [CF/SD Card Connection], [Send Web Site], [Transfer Enhanced Recipe], [Send Security Data], [Receive Security Data]
If you initialize the internal memory, the connection key is erased. After initialization, the first time you start the display unit the Connection key settings screen is displayed. Set the connection key again. When setting the connection key on the GP-4G00 series, use Pro-face Remote HMI.
The connection key is the key that enables communication with the display unit. To protect sending/receiving a project, refer to the following.
34.7 Secure Transfer with Passwords